11/22/2023 0 Comments Hyperterminal linux![]() I know its something obviously stupid which im doing, but when you say "down at the bottom insert the following" i assume you are referring to inserting the code after the last procedure? Im not sure if im putting it in the right place but i have attached a screenshot for you to have a look at. Procedure TDD80f1.SendChars(sToSend:string) procedure TDD80f1.WriteString(sToSend:string) Although i have gone through your guide i am having some issues compiling the program after the. ![]() Having never used Delphi before i have had a chance to mess around with it this weekend and have a look into creating the application in your guide. Arduino: The serial monitor, LCDs and other matters- FAserialĪrduino: The serial monitor, LCDs, the 'map' function, and other mattersįirst of all, thank you tkbyd for the guide you posted, you obviously put a huge amount of work into it. The LED should change over to winking slowly. The LED should be on a fast wink at this point.Įnter "s" (just the letter, no quotes), and press enter. Once that's been uploaded to the Ardy, click on the last icon in the IDE's toolbar, and the serial monitor (controlling PCs end) starts up. Serial.println(", code for s, LED will wink slowly.") } Serial.println(", code for f, LED will wink fast.") } Serial.println("Enter s or f on serial terminal to make wink fast or slow") } Serial.begin(9600) //For access to serial mon channel Int Out0=12 //pin LED will be attached to. Int incomingByte=0 //sloppy: Should be local to loop function Connect the other end of the LED-resistor circuit to ground. Put an LED on pin D13 (along with a resistor). It uses the same serial link that you used to program the Ardy. There's something like Hyperterminal built into the Arduino IDE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |